Ds3/e3, Digital – Network Instruments GigaStor 114ff User Manual
Page 46
Tapping a WAN connection
Chapter 2 Installing Your GigaStor
46
rev. 1
DS3/E3
See “Digital” on page 46 or “Serial/HSSI” on page 48 depending on
your needs.
Digital
The digital DS3/E3 kit includes:
Q
One digital DS3/E3 TAP
Q
One digital DS3/E3 WAN cable
Q
Two full-duplex DS3/E3 coax cables
1
If you have a GigaStor Expandable, see “Connecting the GigaStor
Expandable to the expansion units” on page 52 for details about
connecting them. After connecting them, continue with step 2.
2
Connect the TAP to the GigaStor using the supplied digital DS3/
E3 WAN cable.
3
From your coax cables that connects the router to your CSU/
DSU, unplug the ends of both cables connected to the CSU/DSU
and plug them into the IN ports on the TAP.
4
Using the supplied coax cables, connect them from the OUT
ports on the TAP to the CSU/DSU.
5
Use the supplied Ethernet cable to connect the network interface
card in the GigaStor to the network.
Now that you have physically connected the cables for the GigaStor,
you must now configure its software. See “Setting the GigaStor’s IP
address” on page 19.