Network Instruments GigaStor 114ff - Manual (Page 30)

Connecting Observer to the GigaStor
Chapter 2 Installing Your GigaStor 30
rev. 1
Figure 18 GigaStor Settings Schedule tab
3 In the Schedule GigaStor Capture section, select Always. For
more information about a packet capture vs. GigaStor capture, see
“Packet Capture or GigaStor Capture” on page 53.
4 In the Reserve scheduling for section, select GigaStor and click
OK. You may receive a notice about scheduling reservation. If you
do, click Yes to change the scheduling.
You have installed your GigaStor! Now you must configure some
settings in Observer before getting the maximum results from your
new network analysis tool.
Q
If you are monitoring a Gigabit connection, you must
configure the WAN device. See “Configuring Observer for
your Gigabit device” on page 31 for details.
Q
If you are monitoring a WAN connection, you must configure
the WAN device. See “Configuring Observer for your WAN
device” on page 33 for details.
Q
If you are monitoring any other connection, begin using
Observer to analyze the data. To get started, take use the
GigaStor Control Panel. It is described in “GigaStor Control
Panel” on page 57.