Nortel Networks 5100 - Manual (Page 45)

IP Peer Networking configuration 45
6 For Trunk data block (TYPE), select IP Trunk (IPTI).
7 Type the Terminal Number (TN) for the trunk.
8 For Designator field for trunk (DES), type a meaningful value.
9 For Extended Trunk (XTRK), select Virtual trunk (VTRK).
10 Type the Route number, Member number (RTMB)for the trunk.
11 Set the values of Start arrangement Incoming (STRI) and Start
arrangement Outgoing (STRO).
Immediate (IMM) is recommended for both fields.
12 Type the Channel ID for this trunk (CHID).
13 You can add a Class of Service (CLS) for all features that you wish.
In a basic configuration, you can leave the CLS as is.
14 Select Advanced Trunk Configurations to display a list of
advanced features.
15 Edit the necessary fields or accept the default values.
16 Click Submit.
—End—
Creating the Network Control Block (NCTL) for network access (LD 87)
Complete the following procedure to create the Network Control Block.
Creating the Network Control Block (NCTL) for network access
(LD 87)
Step Action
1 Log onto Element Manager.
2 Select Open Dialing and Numbering Plans > Electronic Switched
Networks.
3 Expand the Customer tab.
See
Figure 17 "Electronic Switched Network (ESN)" (page 47) .
4 Select Network Control and Services > Network Control
Parameter (NTCL).
A message appears if no network control data is configured. Click
OK to configure new data.
5 Next to Network Control Basic Parameters, click the Edit tab.
Enterprise: Common
Solution Integration Guide for Communication Server 1000/Multimedia Communication Server 5100
NN49000-301 01.01 Standard
Release 4.5 27 October 2006
Copyright © 2006, Nortel Networks Nortel Networks Confidential
.