Nortel Networks 5100 - Manual (Page 60)

60 IP Peer Networking and Call Server configuration
Table 7
LD 90 — Service DN for Converged Desktop
Prompt Response Description
REQ NEW Add new data
CUST xx Customer number as defined in LD 15
FEAT NET Network translation tables
TRAN AC1 or AC2 Access Code, where:
AC1 = NARS / BARS
AC2 = NARS
TYPE SPN Special number translation (special
code translation block)
Configure the CDS Service DN as an
SPN, and point it to the SIP trunk. This
number is internal only between the
Call Server and the Signaling Server for
reserving the Virtual Trunk when routing
the terminating CD call out to the MCS
5100.
SPN xxxx Special Number
The same DN must be used on the
Signaling Server in the Service DN field
of the config.ini file.
-FLEN xx Flexible length number of digits Flexible
length is the exact number number of
digits the system expects to receive
before accessing a trunk and outpulsing
those digits.
-RLI xxx Route List Index for Converged Desktop
Service Class of Service (CLS)
The RLI number must point to the SIP
Virtual Trunk on the desired Signaling
Sever. For example, if the CDN and
SPN are configured on Signaling Server
1, then this RLI must use the route
configured on Signaling Server 1.
Configuring Personal Call Assistant (LD 11)
Perform the following procedure to configure Personal Call Assistant (PCA).
Configure a minimum of two PCAs. Configure the number of PCA agents
appropriate for your system’s call volume.
Enterprise: Common
Solution Integration Guide for Communication Server 1000/Multimedia Communication Server 5100
NN49000-301 01.01 Standard
Release 4.5 27 October 2006
Copyright © 2006, Nortel Networks Nortel Networks Confidential
.