National Instruments PCI-1200 - Manual (Page 70)

Appendix A Specifications
PCI-1200 User Manual A-2 © National Instruments Corporation
Max working voltage..............................In DIFF or NRSE
(signal + common mode) ........................mode, the negative
input/AISENSE should remain
within ±5 V of AGND (bipolar),
or –5 to 2 V (unipolar). The
positive input should remain
within the –5 to +10 V range.
Overvoltage protection ...........................±35 V powered on,
±25 V powered off
Inputs protected ...............................ACH<0..7>
FIFO buffer size......................................4,096 samples
Data transfers ..........................................DMA, interrupts,
programmed I/O
DMA mode .............................................Scatter gather
Dither ......................................................Available
Transfer Characteristics
Relative accuracy....................................±0.5 LSB typ dithered,
±1.5 LSB max undithered
DNL ........................................................±1 LSB max
No missing codes....................................12 bits, guaranteed
Offset error
Pregain error after calibration..........10 µV max
Pregain error before calibration.......±20 mV max
Postgain error after calibration ........1 mV max
Postgain error before calibration .....±200 mV max
Gain error (relative to calibration reference)
After calibration...............................0.02% of reading max
Before calibration ............................±2% of reading max
Amplifier Characteristics
Input impedance
Normal powered on .........................100 G
Ω in parallel with 50 pF