National Instruments PCI-1200 User Manual
Page 97
Index
© National Instruments Corporation
I-5
recommended input configurations
(table), 3-8
single-ended connections (NRSE
configuration), 3-13 to 3-14
I
IBF signal (table), 3-27
INL (integral nonlinearity), A-4
input configurations. See analog input
configuration.
installation
hardware installation, 2-1
software installation, 2-1
unpacking the PCI-1200, 1-2
instrumentation amplifier
illustration, 3-6
purpose and use, 3-6
theory of operation, 4-6
integral nonlinearity (INL), A-4
interval scanning DAQ operation
description, 3-21
signal timing (figure), 3-22
theory of operation, 4-8 to 4-9
INTR signal (table), 3-27
I/O connector
exceeding maximum ratings
(caution), 3-1
pin assignments (figure), 3-2
L
LabVIEW application software, 1-1 to 1-2
LabWindows/CVI application software, 1-3
M
manual. See documentation.
mode 1 input timing, 3-28
mode 1 output timing, 3-29
mode 2 bidirectional timing, 3-30
multiple-channel scanned data acquisition, 4-9
multiplexers, analog input, 4-6
mux counters, 4-6
N
NI-DAQ driver software, 1-3 to 1-4
noise, system, A-5
NRSE input
configuration, 2-4 to 2-5
definition (table), 2-4
recommended input configurations
(table), 3-8
single-ended connections for
ground-referenced signal sources,
3-13 to 3-14
O
OBF* signal (table), 3-27
operation of PCI-1200. See theory of
operation.
OUT signals
general-purpose timing signal
connections, 3-23 to 3-26
timing requirements (figure), 3-26
OUTB0 signal (table), 3-4
OUTB1 signal
definition (table), 3-4
interval-scanning signal timing, 3-23
maximum voltage input rating, 3-23
OUTB2 signal (table), 3-4
P
PA<7..0> signal (table), 3-3
PB<7..0> signal (table), 3-3
PC<7..0> signal (table), 3-3
PCI interface circuitry
block diagram, 4-2
theory of operation, 4-2 to 4-3