National Instruments PCI-1200 User Manual
Page 94
Index
I-2
© National Instruments Corporation
analog input signal connections
bipolar signal range vs. gain (table), 3-5
common-mode signal rejection,
3-14 to 3-15
differential connections
floating signal sources, 3-11 to 3-12
grounded signal sources, 3-10
purpose and use, 3-9
when to use, 3-9
exceeding maximum input voltage ratings
(caution), 3-5
floating signal sources, 3-7
ground-referenced signal sources,
3-7 to 3-8
input configurations, 3-7 to 3-15
instrumentation amplifier, 3-6
pins, 3-5
recommended input configurations
(table), 3-8
single-ended connections, 3-12
floating signal sources (RSE
configuration), 3-13
grounded signal sources (NRSE
configuration), 3-13 to 3-14
when to use, 3-12
types of signal sources, 3-7
unipolar signal range vs. gain (table),
3-5 to 3-6
analog input specifications, A-1 to A-6
amplifier characteristics, A-2 to A-3
dynamic characteristics, A-3 to A-4
explanation, A-4 to A-5
input characteristics, A-1 to A-2
stability, A-3 to A-4
transfer characteristics, A-2
analog output
circuitry, 4-11 to 4-12
DAC timing, 4-12
polarity
configuration, 2-3
settings (table), 2-2
signal connections, 3-15 to 3-16
theory of operation, 4-11 to 4-12
analog output specifications, A-6 to A-7
dynamic characteristics, A-7
explanation, A-7
output characteristics, A-6
stability, A-7
transfer characteristics, A-6
voltage output, A-6 to A-7
B
bipolar signal range vs. gain (table), 3-5
bulletin board support, B-1
bus interface specifications, A-9
C
cabling, custom, 1-5 to 1-6
Calibrate_1200 function, 5-3
calibration, 5-1 to 5-3
EEPROM contents, 5-1 to 5-2
equipment requirements, 5-2
higher gains, 5-2
methods, 5-1
overview, 5-1
using the Calibrate_1200 function, 5-3
CLK signals
general-purpose timing signal
connections, 3-23 to 3-26
timing requirements (figure), 3-26
CLKB1 signal (table), 3-4
CLKB2 signal (table), 3-4
CNTINT signal, 3-22
common mode signal rejection considerations,
3-14 to 3-15
ComponentWorks application software, 1-2
configuration
analog input
analog I/O settings (table), 2-2
input modes, 2-3 to 2-5