Connecting the digital entertainer, Connecting the digital entertainer -7, Figure 1-4 – NETGEAR Digital Entertainer EVA700 User Manual
Page 19
Digital Entertainer Model EVA700 User Manual
Installing Your Digital Entertainer
1-7
v1.0, May 2006
Connecting the Digital Entertainer
If you are using a Windows XP computer without Intel® Viiv™ technology,
connect the digital entertainer first, and install the software as explained in
“Windows XP Computer Without Intel® Viiv™ Technology” on page 1-8.
If you are using an Intel® Viiv™ technology, then you must update the software
before you connect the digital entertainer. See Chapter 2, “Intel® Viiv™
Technology”.
The digital entertainer is compatible with the following types of video and audio
cables:
•
Video cable and Audio cable: These two cables are included, and are
compatible with most televisions in the U.S.
•
SCART: This cable is often used in Europe and Australia, and is not
included in the package. However, if you have a SCART cable the digital
entertainer recognizes it, and you can continue to use these instructions.
•
S-Video, or Component Video: These cables are not included in the
package, and you will need to change the digital entertainer settings in
order to use them.
The rear view of the digital entertainer is shown below:
Follow these steps to connect the digital entertainer.
1. Connect the digital entertainer to your television set and audio equipment. If
you use a digital a/v receiver, use S/PDIF coaxial cable to connect it.
2. Connect the digital entertainer to the router with an Ethernet cable.
Figure 1-4
ÍjÁjÍ
.¬jja
Ê 0
2¬
-jÄjÍ
~Н?ЛЦaЛ7ДЦ?Л ÍjÁÍ?jБЛ 7Иее
. -
.7aj
:
¬M
¬Á
¬jÍË7aj
-
.К+ Л ?Ю?
¬ДНjЛ7aj
Цa
ЦН
.W?Áw
+ЭjБ
¤ееФ|е7IyеЙег±Ле|Л?Ю±
Component Video
SCART
S-Video
Stereo Audio
S/PDIF
Ethernet port with LEDs
Composite Video
Coaxial
(audio)