NorthStar Navigation NorthStar 8000i - Manual (Page 150)

150 Northstar 8000i Operation Manual
2. Check that the Chart screen has the Radar Overlay turned On. If not,
turn it on (see "Overlay the radar" in Chart).
3. Select the Radar pane so that it becomes the active pane. If you can't
see the Adjust Radar button, select Return.
4. Select
Adjust Radar, then select Installation.
5. The
Bearing Alignment button shows the current setting. Select
the button if you want to change the setting, then use the Up and
Down buttons or the rotary knob to move the radar image one
degree at a time, until the radar overlay is aligned with the chart.
6. Select
OK to confirm the new setting.
7. When you are finished, select Return.