NorthStar Navigation NorthStar 8000i - Manual (Page 197)

Northstar 8000i Operation Manual 197
42.18 Restore local settings
Use this to restore your local settings if the data has been corrupted.
Local settings apply only to the display unit that you are currently using.
To restore your local settings:
1. Select
Display.
2. Select
Setup from the control panel.
3. Select
+ Restore to display a list of system options.
4. Select
Restore Local Settings.
5. The 8000i displays the Restore Local Settings box with a list of the local
backups for all the display units in the 8000i networked system.
6. Select either:
ƒ the backup that you want to restore, then select Restore
Selected Backup, then select OK to confirm.
ƒ
Restore Factory Defaults to restore the local settings to the
factory defaults, then select OK to confirm.
7. Select
OK again.
8. When you are finished, select Return, then select – Restore.
42.19 Gray screen with message: "Master" name unavailable
If the master unit is NOT operating, all the other display units will show a gray
screen with the message "Master ‘‘name’’ unavailable".
Locate and turn On the master unit. (The master unit MUST be operating in order
for the other processors to function with Chart, Radar, Sounder, and 3D Chart.)
See "Networking the 8000i" for more information.