NorthStar Navigation NorthStar 8000i - Manual (Page 60)

60 Northstar 8000i Operation Manual
Any water at a depth between the safe depth setting and the deep water contour
setting is shown on your Chart screen as a light gray.
Any water that's deeper than the deep water contour is shown in white on your
Chart screen when Shade Safe Depths is Off.
These colors help you to easily identify shallow areas.
To set the deep water contour:
1. Select
Display.
2. Select Setup from the control panel.
3. Select
+ Chart to show a list of charting specification options.
4. The
Deep Contour button shows the current setting. If you want to
change the units, (see "Select the depth units" page 32) .
5. Select
EDIT if you want to change the setting, then enter the new
depth using the onscreen keyboard and select OK.
6. The new setting is applied immediately and stays until you change it
again.
7. When you are finished, select – Chart.
7.11 Show/hide your current track
You can toggle your current track On or Off. If it's On, your current track is shown
as a thin blue line.
If you change this setting, it's also changed on any other display units that are
showing the same Chart view.
To change the track setting:
1. Display the Chart screen and the control panel. If you can't see the
Waypoints, Routes & Tracks button, select Return.
2. Select
Waypoints, Routes & Tracks.
3. The
Track button shows the current setting. Select the button if you
want to toggle to the other setting.
4. The new setting is shown immediately and stays until you change it
again.
5. When you are finished, select Return.
7.12 Show/hide the chart boundaries
You can toggle the chart boundaries On or Off to show or hide the boundaries of
any charts in your licensed chart collection.
If you change this setting, it's also changed on any other display units that are
showing the same Chart view.
To change the chart boundaries setting:
1. Display the Chart screen and the control panel. If you can't see the
Chart Presentation button, select Settings.