NorthStar Navigation NorthStar 8000i - Manual (Page 23)

Northstar 8000i Operation Manual 23
E Confirm Press to select or confirm.
F 4 directional
arrows
Press or hold down an arrow to move in that direction. These work
only for some functions, such as Chart.
G VESSEL Press to return to the selected vessel offset position on your Chart
screen (Look Ahead or Center) or to remove any offset on your Radar
screen.
H IN Press once to zoom in one step.
I OUT Press once to zoom out one step.
J MARK Press to mark the current position with a default event mark icon.
K MOB Press to activate the Man Overboard sequence.
L VOL Press to adjust the volume of the audio that you're playing.
M ALARM Press to show the alarm log and to set up the alarms.
N Power Press to power On. Hold down for about ten seconds to power Off.
2.6 The buttons
Buttons are displayed graphically on the screen. There are two groups of buttons:
•
Page buttons are shown along the bottom of the screen. Just select a button
to show that function or page.
•
Control panel buttons are shown down the right hand side of the screen
when a function is active. The names of the buttons will vary, depending on
the function that you're using. Use these buttons to manage the function.
NOTE: If you can't see the buttons because a pane has been set to maximum view
(for example, when you're viewing a video or DVD) just touch anywhere on the
screen or select Control to re-display the control panel.
2.7 How to select an item
To select an item with the touch screen:
1. Just touch the item gently on the screen.
To select an item with the remote keypad:
1. Use the cursor control pad to move to the item you want to select,
then press the confirm bar.
2.8 Single pane options
You can use the 8000i to view a single function, such as the Chart screen, in one
single pane that takes up the whole screen.
To see the choice of full size, single pane screens:
1. Select
Display to see the single pane screen functions available on
your 8000i.