Ricoh Facsimile - Manual (Page 140)

Simplifying the Operation
130
7
B Perform the Send Later setting
till the procedure of pressing
[OK]
to return to the standby
mode.
Reference
p.3 “Sending at a Specific
Time (Send Later)”
BBBB
Make sure that the machine is in
facsimile mode and the standby
display is shown.
Note
❒ If the standby display is not
shown, press the
{{{{Facsimile}}}} key.
CCCC
Press the {{{{Program}}}} key.
DDDD
Make sure that [Register] is select-
ed.
EEEE
Select a program number in which
“*Not Stored” is shown.
Note
❒ If you make a mistake, press
[Cancel] and select a program
number again.
❒ When you change a Keystroke
Program, press [Register] after
pressing the program number
you want to change. If you
make a mistake, press [Do not
Register]
and return to step E .
FFFF
Enter the program name, and then
press [OK].
The standby display appears.
Note
❒ If you make a mistake, press
[Backspace] or [Delete All], and
then try again.
❒ You should register the pro-
gram name.
❒ To cancel a programmed pro-
gram, press [Cancel]. The dis-
play returns to that of step
E .
Reference
“Entering Text”, General Set-
tings Guide
Registering a priority function using a
program
You can select whether or not the
function registered in program No. 1
will be set after the power is turned
on or the
{{{{Clear Modes}}}} key is pressed.
After registering a function in pro-
gram No. 1, select [Program No.1] for
[Change Initial Mode]
on the Facsimile
Features menu. See p.144 “General
Settings/Adjustment”.
Limitation
❒ You cannot register the following
using program No.1:
• Any destination
• Store File
• Polling Transmission
• Sender Settings
• Specifying a stored file
• Enter Subject of E-mail Options
ZLFS310N
FaxAdEN_Chapter-7 Page 130 Tuesday, December 28, 2004 6:45 PM