Ricoh Facsimile User Manual
Page 219
Specifications
209
11
Limitation
❒ There may be a difference in the size of the image when it is printed at the des-
tination.
❒ If you place an original larger than A3, 11"×17" on the exposure glass, only an
A3, 11"
×17" area is scanned.
Note
❒ Even if an original is correctly placed on the exposure glass or in the ADF, a
margin of 3mm (0.1") around each edge of the original may not be sent.
❒ If the receiver uses paper of a smaller width than the original, the image will
be reduced to fit that paper. See p.74 “Auto Reduce”.
❒ The machine detects paper sizes in the following ways:
• When you place an original in the ADF, an original wider than about
264mm (10.4") is scanned as A3, 11"
× 17" size.
An original narrower than about 230mm (9.1") will be sent as 8
1
/
2
"
× 11" or
8
1
/
2
"
× 14" size, and an original narrower than about 264mm (10.4”) is
scanned as B4 JIS.
Originals up to 1,200mm (47.2") in length can be scanned.
• Refer to the table below for sizes the machine can detect when you place
an original on the exposure glass. Because the machine scans non-standard
size documents in a standard size, part of the image may be truncated de-
pending on the length of the document. For details about how to set non-
standard size documents, see p.15 “Setting a Scan Area”, Facsimile Refer-
ence <Basic Features>.
❖
❖
❖
❖ Metric Version
Length
*1
–approx. 249mm approx. 249mm–
approx. 274mm
approx. 274mm–
approx. 316mm
approx. 316mm–
Wi
dth
–approx.
243mm
×
B5 JIS
L
A4
L
F
L
approx.
243mm–
approx.
268mm
B5 JIS
K
B4 JIS
L
B4 JIS
L
B4 JIS
L
approx.
268mm–
A4
K
A3
L
A3
L
A3
L
JupterC2_Fax_EN-F_FM.book Page 209 Monday, November 29, 2004 3:48 PM