Ricoh Facsimile - Manual (Page 189)

Using Administrator Settings
179
9
Note
❒ If you select [Auto Detect], the
machine recognizes the pa-
per size automatically.
• The machine will detect
the paper size for the by-
pass tray as the short edge
of the paper is inserted
into the machine. Even if
you placed an A4 size
sheet in the
K orientation,
the machine will detect it
as A3
L.
❒ If you select [Standard Size],
select a paper size displayed,
and then proceed to step
G.
❒ If you select [Custom Size],
proceed to step
D.
C Select the size you want to pro-
gram from the sizes shown.
D Make sure that [Vertical] is se-
lected.
E Enter the vertical size of the pa-
per using the number keys,
and then press [
# # # #].
Note
❒ You can specify a vertical
size from 210mm (8.3 inch) to
305mm (12.0 inch). You can-
not enter a size smaller than
2 1 0 m m o r l a r g e r t h a n
305mm.
❒ Each time you press [mm] or
[inch] , the units switch be-
tween “mm” and “inch”. If
y o u e n t e r a l e n g t h a n d
change the units by pressing
[mm]
or [inch], it is converted
automatically (fractions are
rounded off).
F Enter the horizontal size of the
paper using the number keys,
and then press [
# # # #].
Note
❒ You can specify a horizontal
size from 148mm (5.9 inch) to
600mm (23.7 inch). You can-
not enter a size smaller than
1 4 8 m m o r l a r g e r t h a n
600mm.
❒ Each time you press [mm] or
[inch] , the units switch be-
tween “mm” and “inch”. If
y o u e n t e r a l e n g t h a n d
change the units by pressing
[mm]
or [inch], it is converted
automatically (fractions are
rounded off).
G Press [OK].
GGGG
Press [Exit].
HHHH
Press the
{{{{User Tools/Counter}}}} key.
The standby display appears.
JupterC2_Fax_EN-F_FM.book Page 179 Monday, November 29, 2004 3:48 PM