Roland VS-1824 - Manual (Page 125)

125
Add Finishing Touches to Your Song
Add Finishing Touches
to Your Song
17
Press [PLAY]. The song will play back.
18
Raise and lower the master fader, and verify that the volume
of each track changes.
19
Use the channel faders (1–16) to adjust the volume balance of
the tracks. At this time, the sound (volume level and pan) that
is output from the MASTER jacks will be recorded “as is” to
the mastering tracks. Adjust the volume to as high a level as
possible without causing distortion.
20
When you are finished adjusting the volume, press [STOP].
21
Move to the time location at which you wish to begin the
mixdown (e.g., 00h00m00s00f).
22
Press [REC]. The REC indicator will light in red.
23
Press [PLAY]. The PLAY indicator will light in green, and
recording will begin.
24
When you finish recording, press [STOP].
The sound that has passed
through the master fader
will be recorded on the
mastering tracks. In order
to record at the optimal
audio quality, you will
normally set the master
fader to 0 dB.
fig.5-17
Signal Flow (Routing)
TR1
MASTER
MIX
Sw
MIX
L R
Track 1–16
MST TR L
MST TR R
Mastering
Track
MASTER OUT
MONITOR OUT
FX (Insert)