Changing the paper size in tray 2, P.105 “changing, The paper size in tray 2 – Ricoh 270 User Manual
Page 117: P.105 “changing the, Paper size in tray 2
Changing the Paper Size
105
3
Changing the Paper Size in
Tray 2
A
Carry out steps
A-J described in
"Changing the Paper Size in Tray
1 or the Optional Paper Table"
P.103 “Changing the Paper Size in
Tray 1 or the Optional Paper Ta-
ble”.
Note
❒ If the size of paper you wish to
load is not shown on the scale,
slide the paper size selector to
the “p” mark then specify the
paper size and type.
B
Push the switch-over lever to the
left or right depending on the
type of paper you have loaded:
Standard Paper
A Push the switch-over lever to
the left.
Non-standard Paper
e.g. OHP transparencies, transpar-
ent paper, postcards etc.
A Push the switch-over lever to
the right.
Note
❒ When you push the switch-
over lever to the right, you
cannot use the following
functions.
• Sort/Stack/Staple
• Duplex
C
Push the paper tray in until it
stops.
Setting the non-standard size paper
A
Press the 1 key to select the sec-
ond paper tray. Then press the {
#
}
key.
B
Press the
[Pap.Size]
key.