P.48 “auto start—en, P.48 “auto start, P.48 “user codes – Ricoh 270 User Manual
Page 60: User codes
Copying
48
2
Note
❒ The previous copy settings are
recalled and the previous copy
job can be resumed by pressing
the {
Start
} key.
Interrupting copying after all
originals have been fed
A
Press the {
Interrupt
} key.
The Interrupt key lights and copy-
ing will stop.
B
Set your original.
Reference
For functions that cannot be
used together with this func-
tion, see
.
C
Press the {
Start
} key.
The machine starts making your
copies.
D
When copying is complete, re-
move your originals and copies.
E
Press the {
Interrupt
} key again.
The Interrupt indicator goes out.
F
Press the {
Start
} key.
The previous copy job settings will
be restored and the machine will
continue copying from where it
left off.
User Codes
When user codes are turned on, oper-
ators must input their user codes be-
fore the machine can be operated. The
machine keeps count of the number
of copies made under each user code.
Note
❒ When user codes are turned on,
the machine will prompt you for
your user code after the power
switch is turned on or System Re-
set comes into effect.
❒ To prevent others from making
copies using your user code, press
the {
Clear Modes
} and {
Clear/Stop
}
keys simultaneously after copying.
Reference
For setting user codes, see
Auto Start—Entering Copy
Job Settings During the Warm-
up Period
If you press the {
Start
} key during the
warm-up period, the {
Start
} key will
blink and your copies will be made as
soon as warm-up finishes.
A
Make any adjustments to copy
settings during the warm-up peri-
od.
B
Set your originals.
C
Press the {
Start
} key.
The {
Start
} key indicator alternate-
ly flashes red and green.
Note
❒ To cancel Auto Start, press the
{
Clear/Stop
} key.