Regency P33 SunriseTM P33S-LP4 - Manual (Page 15)

Regency P33 Sunrise TM Gas Fireplace 15
INST
ALLA
TION
Wherever necessary due to
external location of cap, the
AstroCap can be replaced with
the FPI Riser Vent Termina-
tion Cap.
REGENCY ® DIRECT VENT FLEX SYSTEM
Horizontal Terminations Only
This venting system, in combination with the P33S-4 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by Warnock
Hersey. The location of the termination cap must conform to the requirements in the "Exterior Vent Terminal Locations" Section .
Regency ® Direct Vent Flex Termination Kit (Part # 946-513) includes all the parts needed to install the P33S-4 with a maximum run of 2
feet. If installing the P33S-4 with a continuous vent length of more than 2 ft (.6m) to a maximum of 10 ft. (3.0m) use Kit # 946-515 (4 ft) or 946-
516 (10 ft) or see "Rigid Pipe Venting Systems" Section for alternate venting arrangements.
MINIMUM
FLEX KIT CENTER-LINE
MINIMUM
RIGID PIPE CENTER-LINE
2
0
6
4
8
2 0 6 4 8
V
ertical
Height
(Feet)
Min.
30"
(762mm)
Horizontal (Feet)
Max. 24"(0.6m)
2
0
6
4
8
2 0 6 4 8
V
ertical
Height
(Feet)
Min.
26”
(660mm)
Horizontal (Feet)
Max. 24"(0.6m)
AstroCap Flex Kits
1 6-7/8" dia. fl exible liner (kit length)
2 4" dia. fl exible liner (kit length)
3 spring spacers (3)
4 thimble (2)
5 AstroCap termination cap (1)
6 screws (12)
7 tube of Mill Pac (1)
8 plated screws (8)
Notes:
1) Liner sections should be continuous
without any joints or seams.
2) Only Flex pipe purchased from Regency ®
may be used for Flex installations.
Alternate
Horizontal
Termination
Caps
INSTALLATION