Regency P33 SunriseTM P33S-LP4 - Manual (Page 22)

Regency P33 Sunrise TM Gas Fireplace 22
INST
ALLA
TION
INSTALLATION
16
2
4
6
8
10
12
14
2
0
0 12 20 6 14
30” (762mm)
Minimum
Height
Requirement
4 8 10 18 16
V
ertical
Height
(Feet)
Horizontal (Feet)
8"(0.2m)
2’ (0.6m)
RIGID PIPE VENTING ARRANGEMENTS
Horizontal Terminations
REGENCY ® DIRECT VENT SYSTEM (FLEX)
(Propane & Natural Gas)
This diagram shows all allowable combinations of vertical runs with horizontal terminations, using one 45 o and one 90 o elbow (two 45 o elbows
equal one 90 o elbow).
Note: Must use optional rigid pipe adaptor (Part # 510-994) when using rigid pipe vent systems. (Refer "Rigid Pipe Venting Systems"
Section)
• Maintain clearances to combustibles.
• Horizontal vent must be supported every 3 feet.
• Firestops are required at each fl oor level and whenever passing through a wall.
A vent guard should be used whenever the
termination is lower than the specifi ed minimum
or as per local codes.
Note: Regency ® Direct Vent System (Flex)
is only approved for horizontal
terminations.
Minimum
Simpson Dura-Vent Center-Line
Minimum
Flex Kit Center-Line
2
0
6
4
8
2 0 6 4 8
V
ertical
Height
(Feet)
Min.
26”
(660mm)
Horizontal (Feet)
Max. 24"(0.6m)
2
0
6
4
8
2 0 6 4 8
V
ertical
Height
(Feet)
Min.
30"
(762mm)
Horizontal (Feet)
Max. 24"(0.6m)