Ricoh FW770 - Manual (Page 20)

Basics
8
1
Recommended Paper
• Standard paper sizes that can be used in this copier are shown below.
• When you make a copy on a non-standard size of paper, set the paper on the
Copy Paper Table.
• Weight of paper suitable for this copier: 51g/m 2 , 14lb to 134g/m 2 , 36lb.
• Do not use the following kinds of paper or a paper jam might occur.
• Bent, folded, or creased paper
• Torn paper
• Perforated paper
• Non-smooth paper
• Slippery paper
• Thin paper that has low stiffness
• Do not make a copy on paper with any kind of coating, such as thermosensi-
tive paper, art paper, aluminum foil, and carbon paper.
A fault might occur.
• Do not use paper with strong curls at the edges or corners. (Curls rising more
than 5mm (1/4") or falling more than 20mm (3/4") over a 40mm (1.5") radius.)
• When you make copies on film, take out the copies delivered to the copy
guide one sheet at a time and place them on a flat surface.
• If copying to natural tracing paper (all pulp, translucent paper) at a relative
humidity of 35% or less
A If the paper was left out of its package for 5 minutes or more, remove the
first 1000mm (39.3") before copying.
B If copies come out wavy or with white spots, use translucent paper instead
of natural tracing paper.
C Always keep the paper in a bag when not using it.
• Store the paper in a sealed polyvinyl bag if not used for a long period.
If it gets humid, paper will curl or wave which can cause a paper jam or part
of the image not to be copied.
Metric version Inch version Bypass Roll Feeder
A0 E (36"
×
48") K K
A1 D (24"
×
36") KL KL
A2 C (18"
×
24") KL KL
A3 B (12"
×
18") KL KL
A4 A (9"
×
12") K K