Ricoh FW770 - Manual (Page 23)

11
2. Copying
Basic Copying (Copying to sheets)
Use bypass table or roll feeder to copy onto paper.
Note
❒ For acceptable types of original and paper, ⇒
P.6 “Recommended Originals”
and
⇒
P.8 “Recommended Paper”.
❒ If you use bypass table, place one sheet of paper at a time on the bypass table
and never insert more than one sheet of paper.
❒ If the copy paper is curled, place it with the curl facing downwards.
❒ When you set A0 size (36"
×
48") paper, to make sure the ends do not touch the
floor and get dirty, lay a wide piece of paper or some other covering on the
floor.
❒ Do not use paper which is cut obliquely, when the difference between the
right side and the left side of the paper is more than 5mm (1/5"), creasing or
a paper jam might occur.
❒ You cannot copy to both sides of the paper at the same time.
❒ The machine needs about 3 minutes to warm up after being turned on before
copies can be made. The machine is warming up when the Wait indicator is
lit, but you can still edit settings, insert copy paper or insert your original.
❒ Set paper, and then set original (from bypass tray or roll feeder). When you
have set both of them, the copier starts copying automatically.
❒ Do not lean on the copy table or lay heavy objects on it.
❒ After finish copying, you can store up to 25 copies.
R
CAUTION:
• If during copying your original gets stuck in the copier, press the
{Emergency Stop}
key.
• If you stop operation by pressing this key, remove both the origi-
nal and paper.