Ricoh FW770 - Manual (Page 80)

Troubleshooting
68
5
D
Hold the paper (
B B B B ), and then slide the cutter (A A A A).
Note
❒ Slide the cutter one way only, otherwise paper waste may pile up inside
the machine.
E
Turn the knob anticlockwise about 1/4 to adjust the paper position.
F
Slowly rotate the paper roll until the edge of the paper is fed into the rub-
ber part of the roller (
A A A A). While feeding the flap of the paper roll into the
rubber part of the roller, turn the paper knob clockwise(
B B B B).
Note
❒ Do not hold the paper knob from side. It may cause you touching a sticky
oil. For how to turn the knob without any harm, see the illustration below:
❒ Make sure that the paper is not loose. Insert it straight into the roller.