Adjusting the fusing temperature manually, A press the, B hold down the – Ricoh FW770 User Manual
Page 40: C press the, Graphic, Plain paper : 1234567, Translucent paper: 1234, Film : 1234
Copy Settings
28
3
Adjusting the Fusing Temperature Manually
A
Press the
{{{{Copy Media}}}} key to turn on the Translucent or Film indicator that
you want.
B
Hold down the
{{{{Copy Media}}}} key for 3 seconds until beep. The indicator
show the current fusing temperature. The unlit indicator shows the current
temperature settings.
C
Press the
{{{{i
i
i
i}
}}} key to decrease the temperature, and press the {{{{j
j
j
j}
}}} key to
increase the temperature. The number of temperature levels (7 levels)
available depends on the paper type:
• Plain paper : 1234567
• Translucent paper: 1234
• Film : 1234
D
After you have finished setting the temperature, press the
{{{{Copy Media}}}} key.
E
Choose any copy settings you require, and then start copying.
Note
❒ The new fusing temperature for the selected paper type is cleared when
you press the
{Clear Modes/Energy Saver} key or turn off the main switch.