Transition Networks MIL-SM2401MAF - Manual (Page 44)

Transition Networks MIL-SM2401MAF
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
38
Mac / Filter Table Commands Set
Commands
Command
Level
Description Defaults Example
mac-address-ta
ble aging-time
[on | off]
mac-address-ta
ble aging-time
[sec.]
or no
mac-address-ta
ble aging-time
Global
configuration
mode
Use the
mac-address-table
aging-time global
configuration
command to set the
length of time that a
dynamic entry
remains in the MAC
address table after
the entry is used or
updated.
Use the no form of
this command to use
the default
aging-time interval.
The aging time
applies to all VLANs.
300 secs
Switch (config)#
mac-address-table
aging-time on
Switch (config)#
mac-address-table
aging-time 333
(Disable)
Switch (config)#
mac-address-table
aging-time off
Or
Switch(config)# no
mac-address-table
aging-time
mac-address-ta
ble table [static
| filter] hwaddr
[MAC address]
vlanid
[VLAN-ID]
Interface
configuration
mode
Use the
mac-address-table
static to add static |
filter addresses to the
MAC address table.
Use the no form of
this command to
remove static entries
from the MAC
address table.
N/A
Switch (config)#
interface
fastEthernet 0/2
Switch (config-if)#
mac-address-table
static hwaddr
004063112233
vlanid 10