Thermador PODM301 - Manual (Page 25)

English 23
Lens
10W
Halogen
Lamp
Fixing
Clip
Housing
Ceramic
Holder
Holder
Clip
Slide
screw
driver tip
here
To replace the halogen bulb on the oven sidewall:
1. Turn off circuit breaker.
2. Remove oven racks.
3.
Slide the tip of a flat blade screw driver between the
fixing clip and the lamp housing.
4. Support the glass lens cover with two fingers along
the bottom edge to prevent the cover from falling to
the bottom of the oven.
5. G ently twist the flat blade screw driver to loosen the
glass lens cover.
6. Remove the glass lens cover and fixing clip.
7. Remove the bulb by grasping and sliding the bulb
straight out until the two prongs have cleared the
ceramic holder.
8. D o not touch the glass of the new replacement bulb
with your fingers. It will cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean
paper towel or facial tissue with the prongs facing
down. Locate the two prongs in the ceramic holder,
gently poking until the two prongs locate in the
ceramic socket.
9. Press in to seat the bulb.
10. Slide the protective lens into the holder clip and
push the other end until the fixing clip snaps back
into the housing.
11. Turn on circuit breaker.
Loosen
glass lens
cover and
remove