Thermador PODM301 - Manual (Page 9)

English 6
Inserting Racks
Flat Rack
The rack is designed with a stop so it will stop before
coming completely out of the oven and not tilt.
Inserting Flat Rack into Oven:
Removing Flat Rack from Oven:
1. Grasp rack firmly on both sides and pull rack toward
you.
2. When the stop is reached, tilt rack up and pull the rest
of the way out.
Telescopic Rack
Inserting Telescopic Rack into Oven:
NOTICE:
The telescopic rack cannot be installed in the lowest rack
position 0.
CAUTION:
To avoid burns, place oven racks in desired
positions before turning oven on. Always use
oven mitts when the oven is warm. If a rack
must be moved while the oven is hot, do not
let oven mitts contact hot heating elements.
Use caution when removing oven racks from
the lowest rack position to avoid contact with
the hot oven door.
To avoid possible injury or damage to the
appliance, ensure racks are installed exactly
per installation instructions and not
backwards or upside down.
1. Grasp rack firmly on
both sides.
2. Insert rack (see
picture).
3. Tilt rack up to allow
stop into rack guide.
4. Bring rack to a
horizontal position and
push the rest of the
way in. Rack should
be straight and flat,
not crooked.
1. Hold the rack on a
slight angle.
2. Engage the rear hooks
in the accessory
brackets.
3. Hold the rack straight.
4. Push the rack in until it
is even with the front
hooks.
5. Lift the rack up.
6. Push the rack in
completely.
7. Engage the rack’s
front hooks in the
accessory brackets.
This is very important
to ensure that the rack
is installed correctly
(see the enlarged
picture).