TANDBERG E5714 - Manual (Page 108)

Operating the Equipment Locally
Page 4-30 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
Action On PID Error Option
To access the Action on PID Error option, press the Action on PID Error
softkey in the Advanced Menu.
Table 4.21: Action on PID Error Options
Selected Option Description
Raise Alarm An error message is displayed if a PID error is found.
Auto Correct If a PID error is found it is automatically corrected.
SNMP Control Option
To access the SNMP Control option, press the SNMP Control softkey in
the Advanced Menu.
Table 4.22: SNMP Control Options
Selected Option Description
No Reply/Initialisation No SNMP reply during initialisation.
No Lockout/Initialisation Reply as modules start to appear.
Display Contrast Option
NOTE…
When this softkey is pressed, the display changes immediately.
To access the Display Contrast option, press the Display Contrast softkey
in the Advanced Menu. This option allows the contrast ratio of the LCD
display to be set. The contrast range is: Very Light, Light, Medium, Dark,
Very Dark. As the key is pressed the display changes.
If the background is set to very dark or very light, the text may not be
visible. In this instance, view the display at an acute angle, this should
enable the text to be seen enough to change the contrast.
No. Services Option (3.1 and later)
To access the No. Services option, press the No. Services softkey in the
Advanced Menu
. There can be up to four services.
Reset On Download Option
To access the Reset On Download option, press the Reset On Download
softkey in the Advanced Menu. the option can be Yes or No. If Yes, the
Encoder automatically reboots following a download, keeping the current
configuration. If No, the Encoder keeps working normally.
Reset Encoder Option
To access the Reset Encoder option, press the Reset Encoder softkey in
the Advanced Menu. A confirmation message appears “Reset Encoder –
Are you sure?”. If Yes is selected the Encoder immediately reboots,
keeping the current configuration. If No, the Encoder keeps working
normally.