TANDBERG E5714 - Manual (Page 32)

Installing the Equipment
Page 2-4 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
FCC
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
2.2 Preliminary Checks
2.2.1 Mechanical Inspection
When taking delivery of an Encoder, check the equipment items delivered
against the enclosed delivery note. Inspect the equipment for damage in
transit. If in doubt, contact Customer Services (see Preliminary Pages).
NOTE…
Do not remove the covers of this equipment as doing so may invalidate any warranties, cause a safety
hazard and/or affect the EMC performance. It may also invalidate any safety tests. Check with
Customer Services beforehand.
2.2.2 Moving the Equipment Safely
Do not place this product on an unstable cart, stand,
bracket, or table. The product may fall, causing serious
injury and serious damage to the product. Use only with a
cart, stand, bracket or table recommended by TANDBERG
Television.
An appliance and cart combination should be moved with care. Quick
stops, excessive force, and uneven surfaces may cause the appliance and
cart combination to overturn.
Do not move or carry the equipment whilst it is still connected to the
supply or other leads, is live or is in operation.
2.3 Installing the Equipment
2.3.1 Fixing Method
The Encoder can be operated mounted in a 19-inch rack. Ensure that it is
firmly and safely located and has an adequate through-flow of air.
Slide the Encoder onto the chassis supports and affix to the rack by means
of an M6 x 18 mm panhead screw in each corner (see Figure 2.1).
Do not use this product as a support for any other equipment.