TANDBERG E5714 - Manual (Page 162)

Operating the Equipment Locally
Page 4-84 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
Frequency Option
To access the Frequency option press the Frequency softkey in the
Satellite Modulator Menu
.
Table 4.103: Frequency Options
Valid Input Range Description
Min:
Max: 950 MHz
1750 MHz
Modulation Option
To access the Modulation option, press the Modulation softkey in the
Satellite Modulator Menu
. This enable the modulation to be switched
On or Off.
Mod Type Option
Refer to Mod Type Option on page 4-79 for details.
Symbol Rate Option
Refer to Symbol Rate Option on page 4-80 for details. Exactly the same
except that Table 4.93 should only contain 2U values because L-Band
output is only available in the 2U.
FEC Rate Option
Refer to FEC Rate Option on page 4-80 for details.
Spectrum Invert Option
Refer to Spectrum Invert Option on page 4-80 for details.
Roll Off Factor Option
Refer to Roll Off Factor Option on page 4-80 for details.
Tx Bandwidth Factor Option
Refer to Tx Bandwidth Factor Option on page for details.
Tx Bandwidth Option
The Tx Bandwidth option value cannot be updated. It should only be used
as an approximate value as it depends on the performance of external
equipment as well.
Bit-rate (188) Option
The Bit-rate (188) option value cannot be updated.
Bit-rate (204) Option
The Bit-rate (204) option value cannot be updated.
Preset Pwr Low Option
Refer to Preset Pwr Low Option on page 4-81 for details.