Scope of this manual, Who should use this manual, Build version – TANDBERG E5714 User Manual

Page 11: What equipment is covered by this manual, Equipment models, 1 scope of this manual, 1 who should use this manual, 2 build version, 3 what equipment is covered by this manual

Advertising
background image

Introduction to the Basic Encoder

Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder

Page 1-3

ST.TM.E10076.3

1.1

Scope of this Manual

1.1.1

Who Should Use This Manual

This manual is written for operators/users of the 1U and 2U Voyager

Encoders to assist in the installation, operation and day-to-day care. These

Encoders are referred to throughout this manual as ‘Encoder(s)’ unless

there is a specific difference, where they will be referred to by the model

number.

WARNING…

DO NOT REMOVE THE COVERS OF THIS EQUIPMENT. HAZARDOUS VOLTAGES ARE PRESENT

WITHIN THIS EQUIPMENT AND MAY BE EXPOSED IF THE COVERS ARE REMOVED. ONLY

TANDBERG TELEVISION TRAINED AND APPROVED SERVICE ENGINEERS ARE PERMITTED TO

SERVICE THIS EQUIPMENT.

CAUTION…

Unauthorised maintenance or the use of non-approved replacements may affect the equipment

specification and invalidate any warranties.

This manual does not include any maintenance information or procedures

which would require the removal of covers.

1.1.2

Build Version

This manual has been written to cover the functionality in Table 1.1.

Table 1.1: Build Version

E5714, E5740, E5715, E5750

Build Version

2.1.0 – 3.1.0 and later

The Build version indicates the status of the Encoder and refers to an

overall number which encompasses all the various software/firmware

versions of video, audio, etc. in the basic Encoder.
The current Build version can be found in the Build Menu (see Chapter 4,

Operating the Equipment Locally, Figure 4.9).

This number should be

quoted in all correspondence with TANDBERG Television.
This manual continues to be relevant to subsequent Build versions where

the functionality of the equipment has not changed. When a new issue of

the Build version changes the functionality, a new issue of this manual is

provided.

1.1.3

What Equipment is Covered by This Manual

Equipment Models

Each model of Encoder comprises an enclosure with a Base Board and

Modulator fitted as standard. The E5714 and E5740 are fitted with a

Satellite Modulator; the E5715 and E5750 are fitted with an OFDM

Modulator.

Advertising
This manual is related to the following products: