TANDBERG E5714 - Manual (Page 111)

Operating the Equipment Locally
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder Page 4-33
ST.TM.E10076.3
Input Source Select
NOTE…
This option is available in Build version 3.1.0 and later.
To access the Input Source Select option, press the Input Source Select
softkey from the Video Source Menu. This allows the enabling or disabling
of automatic frame rate detection.
Table 4.24: Input Source Select Options
Selected Option Description
Manual The frame rate must be set via the Frame rate option.
Auto Frame Rate The frame rate is automatically detected.
Auto Config Switch The frame rate is automatically detected, and the Encoder loads the
appropriate config defined by Default 525 Config and Default 625
Config.
Figure 4.11: Setting up the Video Input
Frame Rate Option
NOTE…
The frame rate is only shown when the video input is Serial Digital, any Test Pattern or Off.
To access the Frame Rate option, press the Frame Rate softkey from the
Video
Source Menu.
E57xx Encoder
Setup/Video/Encoder
Profile/Level Option
Test
Pattern
Encoding
Setup/Video Source
Source Option
Setup/Video/Encoder
Compression Mode
Encoding
4:2:0 (MP@ML)
4:2:2 (422P@ML)
(option) Standard
Low Delay
Very Low Delay
Mega Low Delay
Seamless 1-6
Set up the Video in this sequence
Serial Digital Video In SDI
COMP VIDEO
Analogue Video