TANDBERG E5714 - Manual (Page 109)

Operating the Equipment Locally
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder Page 4-31
ST.TM.E10076.3
CAUTION…
The Reset Encoder option is not normally used.
One example of its use is when code has been downloaded in background mode (such as Base Board
code or Video Compression Module (VCM) code) and you want to reset the Encoder, to action the new
code.
4.7.7 Build Menu
The Build Menu is selected from the System Menu by pressing the Build
softkey. The Build Menu shows the status of the options shown in
Figure 4.9. They cannot be changed.
4.8 Video Menu
4.8.1 Introduction
The Video Menu is selected from the Setup Menu by pressing the Video
softkey. This menu permits the selection of video parameters. Any option
with a clear circle next to it cannot be accessed and changed. It is for
status information only (see Figure 4.10 for menu structure).
4.8.2 Video Source Menu
Overview
The Video Source Menu is selected from the Video Menu by pressing the
Video Source softkey. This menu permits the selection of video source
parameters. The screens vary according to the type of video source
selected.
Video Input Option
To access the Video Input option, press the Video Input softkey from the
Video
Source Menu.
Table 4.23: Video Input Options
Video Type Selected Option Description
None Off Video input switched off.
PAL-B/G/H/I PAL-B/G/H/I composite video input on COMP VIDEO connector.
PAL-D PAL-D composite video input on COMP VIDEO connector.
PAL-M PAL-M composite video input on COMP VIDEO connector.
NTSC with Pedestal NTSC-M composite video input (with Pedestal) on COMP VIDEO connector.
Analogue
Composite
NTSC No Pedestal NTSC-M composite video input (with no Pedestal) on COMP VIDEO connector.
Serial Digital Serial digital video input on SDI IN connector.
Bars & Red Colour bars and red internal test pattern.
Black Black internal test pattern.
Moving Pattern Moving internal test pattern.
Ident, Digital
and Internal
Test Pattern
Video
Sources
Ident Video Source which allows the user to superimpose identification text on the
video. Mainly used for test purposes.