Toshiba RAV-SM800XT-E - Manual (Page 34)

– 32 –
<Remote controller usage>
• Under Ceiling Installation
Fig. 9-5-1
•
Console Installation
Fig. 9-5-2
9-5-1. Installation Place
•
A place which provides the spaces around the
indoor unit as shown in the above diagram.
•
A place where there is no obstacle near the air inlet
and outlet.
•
A place that allows easy installation of the piping to
the outdoor unit.
•
A place which allows the Front panel to be opened.
9-5-2. Before Installation
<Remove the Air inlet grille>
1. Open the Air inlet grille by both hands.
2. Loosen three screws for fixing the Panel arm. Do
not remove the screws at this time.
Fig. 9-5-3
3. First, move the Air inlet grille upward, then turn it
backwards.
4. Remove the Grille stopper from the axis of the Front
panel. After that, remove the Air inlet grille.
5. Remove the Panel arms from the Front panel.
Fig. 9-5-4
9-5-3. After Installation
<Install the Air inlet grille>
1. Insert the three Panel Arms on the Air inlet grille
and fix each securely by screws.
Fig. 9-5-5
Screw Panel arm
Grille stopper
Panel arm
Panel arm
Reception range
Reception
range
Remote controller
Ceiling
Wall
Reception
range
Remote
controller
Reception
range
Floor
Wall
* Axial distance
5 m
5 m
*7 m
7 m
5 m
5 m
*7 m
7 m
Remote controller
Remote
controller
CAUTION
•
The screws that fixed with Panel Arms must not
be loose.
NOTICE
The Paper pattern is inside the package box cover.
Do not bend and dispose of it before installing.
1
1 2 2
5
3
3
CAUTION
• Direct sunlight or fluorescent light to the indoor
unit’s wireless receiver should be avoided.
• The microprocessor in the indoor unit should not
be too close to RF noise sources.
(For details, see the owner’s manual.)
<Remote controller>
•
A place where there are no obstacles such as a
curtain that may block the signal from the indoor unit.
•
Do not install the remote controller in a place
exposed to direct sunlight or close to a heating
source, such as a stove.
• Keep the remote controller at least 1 m apart from
the nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
•
The location of the remote controller should be
determined as shown below.