VXI VT1422A - Manual (Page 296)

294 VT1422A Command Reference Chapter 7
FORMat
Note
*TST? leaves the instrument in its power-on reset state. This means that
the ASC,7 data format is set even if something else had been set before executing
*TST?. If the FIFO needs to read for test information, set the format after *TST? and
before reading the FIFO.
•
Related Commands: [SENSe:]DATA:FIFO:
…?, [SENSe:]DATA:CVTable?,
MEMory subsystem and FETCh?, Also see how DIAG:IEEE can modify
REAL,32 returned values.
•
*RST Condition: ASCII, 7
•
After *RST/Power-on, each channel location in the CVT contains the IEEE-754
value "Not-a-number" (NaN). Channel readings which are a positive overvoltage
return IEEE +INF and a negative overvoltage return IEEE -INF. The NaN, +INF
and -INF values for each format are shown in the following table.
Table 7-1. Data Formats
•
Send with VXIplug&play Function: hpe1422_cmd(...)
Usage FORMAT REAL
Set format to IEEE 32-bit Floating Point
FORM REAL, 64
Set format to IEEE 64-bit Floating Point
FORMAT ASCII, 7
Set format to 7-bit ASCII
Format IEEE Term Value Meaning
ASCii +INF +9.9E37 Positive Overload
-INF -9.9E37 Negative Overload
NaN +9.91E37 No Reading
REAL,32 +INF 7F800000
16
Positive Overload
-INF FF800000
16
Negative Overload
NaN 7FFFFFFF
16
No Reading
REAL,64 +INF 7FF000...00
16
Positive Overload
-INF FFF000..00
16
Negative Overload
NaN 7FFFFF...FF
16
No Reading
PACKed,64 +INF 47D2 9EAD 3677 AF6F
16
(+9.0e37
10
) Positive Overload
-INF C7D2 9EAD 3677 AF6F
16
(-9.0e37
10
) Negative Overload
NaN 47D2 A37D CED4 6143
16
(+9.91e37
10
) No Reading