VXI VT1422A - Manual (Page 25)

Getting Started 25 Chapter 1
Installing Signal
Conditioning
Plug-Ons
The following illustrations show the steps used to install Signal
Conditioning Plug-ons (SCPs). Before installing an SCPs, reading the
"Separating Digital and Analog SCP Signals" in Appendix E page 483 is
recommended.
Caution Use approved Static Discharge Safe handling procedures
anytime the covers are removed from the VT1422A or when
handling the SCPs.
Remove 2 screws (#10 Torx);
lift front and slide out tabs
1
2
Remove the SCP
Retaining Screws
Installing SCPs: Step 1, Removing the Cover VT1422A