Command sequence, Calibration:tare:reset – VXI VT1422A User Manual

Page 274

Advertising
background image

272 VT1422A Command Reference

Chapter 7

CALibration

The VT1422A's Flash Memory has a finite lifetime of approximately 10,000

write cycles (unlimited read cycles). While executing CAL:STOR once every
day would not exceed the lifetime of the Flash Memory for approximately
27 years, an application that stored constants many times each day would
unnecessarily shorten the Flash Memory's lifetime. See Comments below.

Executing CAL:TARE sets the Calibrating bit (bit 0) in Operation Status Group.

Executing CAL:TARE? resets the bit.

Because CAL:TARE also performs a *CAL? operation, completion of

CAL:TARE may take many minutes to complete. The actual time it takes the
VT1422A to complete CAL:TARE depends on the mix of SCPs installed.
CAL:TARE performs literally hundreds of measurements of the internal
calibration sources for each channel and must allow seventeen time constants
of settling wait each time a filtered channel's calibrations source value is
changed. The CAL:TARE procedure is internally very sophisticated and results
in an extremely well calibrated module.

Any output type channels in <ch_list> are ignored during CAL:TARE.

When Accepted: Not while INITiated

Related Commands: CAL:TARE?, CAL:STOR TARE,

DIAG:CAL:TARE:OTD:MODE

*RST Condition: Channel offsets are not affected by *RST.

Send with VXIplug&play Function: hpe1422_cmd(...)

Command

Sequence

CAL:TARE <ch_list>

to correct channel offsets

CAL:TARE?

to return the success flag from the
CAL:TARE operation

CAL:STORE TARE

Optional depending on necessity of long
term storage

CALibration:TARE:RESet

CALibration:TARE:RESet

resets the tare calibration constants to zero for all

64 channels. Executing CAL:TARE:RES affects the tare cal constants in RAM only.
To reset the tare cal constants in Flash Memory, execute CAL:TARE:RES and then
execute CAL:STORE TARE.

Send with VXIplug&play Function: hpe1422_cmd(...)

Command

Sequence

CAL:TARE:RESET

to reset channel offsets

CAL:STORE TARE

Optional if necessary to reset tare cal
constants in Flash Memory.

Advertising
This manual is related to the following products: