VXI VT1422A - Manual (Page 313)

VT1422A Command Reference 311 Chapter 7
MEMory
MEMory:VME:STATe
MEMory:VME:STATe <enable> enables or disables use of the VME memory card
as additional reading storage.
Parameters
Comments •
This command is only available in systems using an Agilent/HP E1405B/06A
command module.
•
When the VME memory card is enabled, the INIT command does not terminate
until data acquisition stops or VME memory is full.
•
Related Commands: Memory subsystem and FETCH?
•
*RST Condition: MEM:VME:STAT OFF
Usage MEMORY:VME:STATE ON
enable VME card as reading storage
MEM:VME:STAT 0
Disable VME card as reading storage
MEMory:VME:STATe?
MEMory:VME:STATe? returned value of 0 indicates that VME reading storage
is disabled. Returned value of 1 indicates VME memory is enabled.
Comments •
This command is only available in systems using an Agilent/HP E1405B/06A
command module.
•
Returned Value: Numeric 1 or 0. data type uint16.
•
Related Commands: MEMory subsystem and FETCH?
Usage MEM:VME:STAT?
Returns 1 for enabled, 0 for disabled
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
enable boolean (uint16) 1 | 0 | ON | OFF none