VXI VT1422A - Manual (Page 363)

VT1422A Command Reference 361 Chapter 7
[SENSe]
•
*RST Condition: Reference temperature is 0
°C.
•
Send with VXIplug&play Function: hpe1422_cmd(...)
Usage SENSE:REF:TEMP:POST 40,(@10008:10015)
channels 10008 to 10015 will assume
compensation junction at 40 °C
[SENSe:]REFerence:THERmistor:RESistance:POST
[SENSe:]REFerence:THERmistor:RESistance:POST <resistance>,(@<thr_list>)
specifies the sum of the resistor values in the thermistor divider circuit (see Figure 5-5
on page 173) for the thermistor channels in <thr_list> when using the VT1529B to
make a reference temperature measurement. Note: Setting this value for any channel
on a VT1529B also sets the value for all other channels on that VT1529B.
This command is valid only on the VT1529B and is available with VXIplug&play
driver revision A.01.09 or later (revision A.01.06 or later of hpe1422_32.dll).
Parameters
Comments •
When Accepted: Not while INITiated
•
Related Commands: SENS:REF:POST
•
*RST Condition: SENS:REF:THER:RES:POST 400000
•
Send with VXIplug&play Function: hpe1422_cmd(...)
Usage SENSE:REF:THER:RES:POST 397000,(@10001)
divider circuit for thermistor on channel
10001 has 397 k
Ω total resistance
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
resistance numeric (float32) 1800 to 520,000 ohms
thr_list channel list (string) 10000 - 15731 none