VistaQuest N7227V5 - Manual (Page 34)

– 34 –
3. ✱ 24. RF HOUSE ID CODE
The House ID identifies a 5827 or 5827BD Wireless keypad if it is used
(enter 01–31). The wireless keypads should be set to the same ID. If no
wireless keypad is to be used, leave as “00”.
Enrolling 5800 Transmitters Into The System
There are two methods that may be used to enroll transmitters. The first method is performed
in
✱ 56 zone programming mode (which is contained in this section) and describes how to enroll
each transmitter into the system as you are entering the zone information.
The second method is called "sequential enrollment", which uses ✱ 83 mode (contained in the
SEQUENTIAL MODE section later in this manual). This section describes how to enroll all the
transmitters into the system
after all zone information has been entered.
As an option, the zone programming and sequential modes allow you to use a 5803 or 5804
button-type transmitter as a "program tool.” The upper left-hand and right-hand buttons of the
“tool” duplicate the
✱ and # keypad programming functions (left = ✱ , right = #). The advantage
of using a program tool is that it enables remote enrolling. You can move to the physical
location of the transmitter to be enrolled, press the upper left-hand button of the program tool,
and then trip the intended transmitter (see step 10 for operation).
The transmitter that you use as the program tool can also be used as a transmitter in the
system. If you plan to use an existing transmitter, it must first be enrolled into the system as its
associated zones. You may then program it as the tool.
Batteries can remain in the transmitters after the transmitters have been enrolled
into the system. However, to prevent possible problems, make sure these
transmitters are not faulted while other transmitters are being enrolled. Wireless
motion detectors should be covered or placed face down to prevent transmissions.
Enrolling Through Zone Programming ( ✱ 56)
1. Enter Programming mode [Installer Code] + 8 + 0.
Enter Zone Programming by pressing
✱ 56. If the system has been set
up to use 5800 series RF, and a program tool has been entered, skip
to step 4. If no program tool has been entered, the following prompt
will appear:
Program Tool?
0 = No, 1 = Yes 0 2. If a program tool is being used, enter "1." If not using a tool, enter "0"
and skip to Step 4.
00 Input S/N: L
A
X X X–X X X X
3. If "1" is entered, the system will prompt for the unit’s serial number.
Enter the program tool’s serial number using one of the following
methods:
a) Enter the 7-digit serial number for the transmitter
or
b) Press any button on the transmitter. The keypad should beep twice
and display the serial number of the tool.
00 Input S/N: L
A123-4567 3
In this example, the serial number is A123-4567. Once enrolled, the
upper left-hand button of the program tool can be pressed to ready the
system for enrolling a transmitter into the system.
Pressing the [#] key on the keypad will cause the system to back up to
the “Program Tool ?” prompt.
The serial number for the program tool will only remain in the
system until the programming mode is exited. (Entering
✱ 97 will
not delete the tool.)
Press [ ✱ ] to continue.
En te r Zn Nu m .
( 0 0 = Q u it) 1 0
Zone 10 entered
↑
4. Enter the zone number that you wish to program. As an example, zone
10 is shown here.
Press [ ✱ ] to continue.