VistaQuest N7227V5 - Manual (Page 49)

– 49 –
Section 8. EXTERNAL SOUNDERS
This section provides a list of compatible sounders , connection information for
an external sounder and programming procedures for those options that affect
the operation of external sounders .
Compatible Sounders
Ademco AB-12M 10”
Motorized Bell & Box Motor bell & box. UL Grade A. 100mA current
draw.
Ademco 1011BE12M
10” Motorized Bell &
Box Motor bell & box. UL Listed. 100mA current draw.
Ademco 702
Outdoor Siren Self-contained 6–12 volt siren (driver built-in) and
weatherproof for outdoor use. Can be wired for
either a steady or warble sound. 117dB @ 10
feet. 1500mA current draw.
Ademco 719
2-Channel Siren Self-contained 6–12-volt siren (driver built in).
Steady or warble sound. 109dB @ 10 feet.
550mA current draw.
Ademco 747
Indoor Siren Self-contained 6–15 volt siren (driver built-in) for
indoor wall mount. 747F available for flush
mounting. 105dB @ 10 feet. 400mA current draw.
Ademco 747UL
Indoor Siren Self-contained 6–15 volt siren (driver built-in) for
indoor wall mount. UL Listed. 85dB @ 10 feet.
320mA current draw.
Ademco 744
Siren Driver 6 jumper-selected sound outputs. Rated at 119dB
with use of an 8-ohm 30 watt speaker. 1.3 amps
current draw.
Ademco 745X3*
Voice Siren Driver 12 volt voice siren driver with English, Spanish
and French voice messages. Separate messages
for Fire and Burglary. Use with 8-ohm speaker.
UL Listed. 1100mA current draw.
Ademco 705–820,
5-inch Round Speaker 20-watt, 8-ohm indoor or outdoor speaker.
Requires a driver.
Ademco 713 Speaker 40-watt, 8-ohm, indoor/outdoor speaker. Requires
a driver.
System Sensor PA400B
(beige)/ PA400R (red)
Indoor Piezo Sounder Indoor piezo sounder (red or beige), rated at 90
dB @ 10 feet.
* Requires special power wiring, using additional components.
UL
• Use only UL Listed sounding devices for UL installations.
• The total current drawn from the alarm output and the auxiliary power
output, combined, cannot exceed 600mA. In addition, the sounding device
must be a UL Listed audible signal appliance rated to operate in a 10.2-13.8
VDC voltage range, and must be mounted indoors. Example: Wheelock
Signals Inc. siren model 34T-12 (provides 85dB[A] for NFPA 74 & Standard
985).
Non-UL Installations
The total current drawn from the alarm output terminals cannot exceed 2
amps. The back-up battery must be installed since this current is supplied by
that battery.
Going beyond the limits indicated (2 amps) will overload the power supply, or
may cause the electronic circuit protecting the sounder output to trip.