VistaQuest N7227V5 - Manual (Page 66)

– 66 –
TABLE OF CONTACT ID EVENT CODES
Code Definition
110 Fire Alarm
121 Duress
122 Alarm, 24-hour Silent
123 Alarm, 24-hour Audible Panic
131 Alarm, Perimeter, Burg.
132 Alarm, Interior, Burg.
134 Alarm, Entry/Exit, Burg.
135 Alarm, Day/Night, Burg.
150 Alarm, 24 Hour Auxiliary
301 AC Power
302 Low System Battery/Battery Test Fail
333 Expansion Module Fail
353 Long Range Radio Trouble
373 Fire Loop Trouble
Code Definition
374 Exit Error Alarm
380 Trouble (Global)
383 RF Sensor Tamper
384 RF Sensor Low Battery
401 O/C by User
406 Cancel by User
407 Remote Arm/Disarm (Download)
408 Quick Arm AWAY/MAX
441 Armed STAY/INSTANT, Quick Arm
STAY/INSTANT
570 Bypass
601 Test, Manually Triggered
602 Periodic Test
606 AAV to follow
Communication Programming
Introduction
This section provides instructions for programming those fields that affect communications
between the control and the central station.
Programming Procedure
1. With at least one Alpha keypad (5137AD or 6139) connected to the
system, power up the system. If necessary, refer to the FINAL POWER
UP section for the power-up procedure. If you had previously connected
the AC transformer to the control panel, you need only plug in the
transformer (to 120VAC outlet) to power up the system.
2. Enter the programming mode by keying the following on the Alpha
keypad: Installer code (4 1 1 1) + 8 + 0.
Fields ✱ 40, ✱ 41, ✱ 42:
Enter up to the number
of digits shown. Do not
fill unused spaces.
Enter 0–9,
# + 11 for ‘ ✱ ’
# + 12 for ‘#’
# + 13 for a pause
(2 secs)
Press ✱ 40 PABX ACCESS CODE
Enter up to 4 digits if PABX is needed to access an outside line. If fewer than
4 digits are needed to be entered, exit by pressing [
✱ ] and next field number
(e.g., 41). To clear entries from field, press ✱ 40 ✱ .
Press ✱ 41 PRIMARY PHONE No .
Enter up to 12 digits. If fewer than 12 digits entered, exit by pressing [ ✱ ] and
next field number (e.g., 42). To clear entries from field, press ✱ 41 ✱ .
Press ✱ 42 SECONDARY PHONE No.
Enter up to 12 digits. If fewer than 12 digits entered, exit by pressing [ ✱ ] and
next field number (e.g., 43). To clear entries from field, press ✱ 42 ✱ . If using
the Paging feature, enter the pager number as the secondary phone
number.
Press ✱ 43 SUBSCRIBER ACCOUNT. No.
Field ✱ 43 is also
used as the Long
Range Radio
Subscriber Account
Number
Central Station Account Number).
Enter 0–9; # + 11 for B; # + 12 for C; # + 13 for D; # + 14 for E; # + 15 for F
(default).
Enter
✱ as the fourth digit if a 3-digit account number (for 3+1 dialer reporting
format) is used. Enter 0 as the first digit of a 4-digit account number for Nos.
0000–0999. End field by pressing
✱ (and press next field).
See the blank Programming Form in the separate Programming Guide for
examples of Account No. entries.