Westell Technologies 2200 - Manual (Page 83)

030-300354 Rev. B 79 July 2003
Section 12-Configuration
Westell Dual Connect NAT Router User Guide
If you clicked on enable, the following Host Service screen will be displayed. Click on OK. This will load the new
NAT Configuration and the settings will be saved automatically.
If you clicked on OK in the preceding pop-up screen, the Host Device screen will be displayed. The Host Device
screen will allow you to select which device will host the NAT service you selected on your local area network.
Select the device from the Host Device pull-down arrow and click on done.
NOTE: You can attach multiple NAT services to your profile. However, for each NAT service that you attach to
your profile, you must first select the new NAT service. Then, you must load the new NAT Configuration, as
explained earlier in this section.