Xerox 4520 - Manual (Page 190)

D i s p l a y e d C o n t r o l P a n e l M e s s a g e s
7-16 ❖ 4 5 2 0 / 4 5 2 0 m p U s e r ’ s G u i d e
Power Saver
On Power consumption is reduced by means of the power saver mode.
When no printing has occurred for 60 minutes, the printer will automatically go
into Power Saver mode.
ACTION: None. Treat this message just as you would the message:
Online ___
Ready
Press * The printer has a PCL error.
ACTION: Press Enter
This message functions with the System Menu option Auto Continue
(page 3-59). When Auto Continue is On , this message is cleared automatically
after ten seconds, and normal printing operation resumes.
Press a key... The printer has just been taken offline.
ACTION: No more processing can take place until you press another key (any key).
Press
↑
to init
Press
↓
to Abort
Either the hard disk’s partition block cannot be understood or it has a bad high
level format.
This message flashes alternately with either:
Unknown Disk
or
Disk Format Bad
Processing... Printer is processing data from a computer for printing.
ACTION: None
PS Font List
Printing... List of PostScript fonts (page 3-65) is printing.
ACTION: None
Ready Printer is online and waiting for data to print.
ACTION: None
Ready to Print The print engine is not communicating with the system controller.
ACTION: Inspect the system controller to ensure that all wire harness connections
are plugged in. If they are not, contact your dealer or Xerox / Rank Xerox.
Remove Paper
From Bypass Manual bypass slot (SBF or MBF) has a sheet inserted.
ACTION: Remove the sheet so that paper can be fed from a different tray.
Figure 7.2 Control Panel messages (continued)
Message Description/Action
WUG-CH07 Page 16 Black,Red,Cyan Wednesday, January 25, 1995 3:45 PM