Xerox 4520 - Manual (Page 193)

D i s p l a y e d C o n t r o l P a n e l M e s s a g e s
C h a p t e r 7 : T r o u b l e s h o o t i n g ❖ 7-19
Upper Tray Out The upper tray has been removed or is not properly inserted.
ACTION: Insert upper tray.
Waiting... The printer was busy processing data from a host but the print job was not
completed.
This message appears until:
• Another print job is received.
• The Port Timeout expires and Auto Job End is On . See Chapter 3: Using the
Control Panel , “Interface Menu” (page 3-38) .
• The last page timeout expires.
• The PostScript “waittimeout” expires. Refer to the PostScript reference
documentation.
ACTION: None
Warming up
Please Wait... Fuser has not warmed up yet.
Message disappears when the printer is ready. The message displays at power-on
and may display after the cover has been opened for some time or when the
printer is exiting power-saver mode.
ACTION: None
Warning 300/A3 This message appears in PCL when the printer has changed resolution to 300 or
page protection to A3; appears in PostScript when the page size is A3 and the
printer has changed resolution to 300.
This is a transient warning to advise that, due to insufficient memory to print with
the requested settings, either the resolution or page protection has been changed.
The message clears when the next job starts.
ACTION: None
Warning 300/A4 This message appears in PCL when the printer has changed resolution to 300 or
page protection to A4; appears in PostScript when the page size is A4 and the
printer has changed resolution to 300.
This is a transient warning to advise that, due to insufficient memory to print with
the requested settings, either the resolution or page protection has been changed.
The message clears when the next job prints.
ACTION: None
Figure 7.2 Control Panel messages (continued)
Message Description/Action
WUG-CH07 Page 19 Black,Red,Cyan Wednesday, January 25, 1995 3:45 PM