Xerox 4520 - Manual (Page 73)

P C L M e n u
C h a p t e r 3 : U s i n g t h e C o n t r o l P a n e l ❖ 3-19
Figure 3.8 PCL Menu options showing factory settings
Option Setting Description
Copies 1* - 99 Number of times each page is printed.
Most software applications override this setting. If
your application does not, the printer assumes the
default setting here.
Font Source Internal*
Upper
†
Lower
†
Soft †
† Upper and Lower appear
only when a font card is
installed.
Soft appears
when there is a
downloaded font.
Location of the default font in PCL.
Internal refers to the font set residing in the printer’s
permanent memory. These fonts are resident in the
printer and cannot be altered.
Upper and Lower refer to the two font card slots and
appear only when a font card is installed in a slot. See
Chapter 1: Introduction (page 1-3) for location of the
font card slots.
When a font card contains its own default font, the
current
Font Source setting is overridden. You must
change the Font Source setting if you do not want to
use the default font on the font card.
Soft refers to fonts permanently downloaded to either
printer memory or to a printer hard disk. Soft appears
only if there is a permanently downloaded font.
The Font Source setting returns to its
factory setting (“ Internal ”) if Symbol Set
(page 3-25) is changed.
If the Font Source setting specifies a
location other than “ Internal ,” Font
Number (page 3-20) reverts to 0
automatically.
Note
WUG-CH03 Page 19 Black,Red,Cyan Tuesday, March 21, 1995 4:54 PM