ZyXEL Communications XGS-4526 User Manual
Page 214
Chapter 24 Multicast
XGS-4526 User’s Guide
214
Click Advanced Applications > Multicast > Multicast Setting > IGMP
Filtering Profile link to display the screen as shown.
Figure 104 Advanced Application > Multicast > Multicast Setting > IGMP Filtering
Profile
The following table describes the labels in this screen.
Table 64 Advanced Application > Multicast > Multicast Setting > IGMP Filtering
Profile
LABEL
DESCRIPTION
Profile Name
Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added,
enter the profile name and specify a different IP multicast address
range.
Start Address
Type the starting multicast IP address for a range of multicast IP
addresses that you want to belong to the IGMP filter profile.
End Address
Type the ending multicast IP address for a range of IP addresses that
you want to belong to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the
Start Address and End Address fields.
Add
Click Add to save the profile to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Clear
Click Clear to clear the fields to the factory defaults.
Profile Name
This field displays the descriptive name of the profile.
Start Address
This field displays the start of the multicast address range.
End Address
This field displays the end of the multicast address range.