ZyXEL Communications XGS-4526 - Manual (Page 88)

Chapter 8 Basic Setting
XGS-4526 User’s Guide
88
The following table describes the labels in this screen.
Table 14 Basic Setting > IP Setup
LABEL DESCRIPTION
Default
Gateway Type the IP address of the default outgoing gateway in dotted decimal
notation, for example 192.168.1.254.
Domain
Name Server DNS (Domain Name System) is for mapping a domain name to its
corresponding IP address and vice versa. Enter a domain name server IP
address in order to be able to use a domain name instead of an IP address.
Default
Management Specify which traffic flow (In-Band or Out-of-band) the Switch is to send
packets originating from itself (such as SNMP traps) or packets with
unknown source.
Select Out-of-band to have the Switch send the packets to the
management port labelled MGMT. This means that device(s) connected to
the other port(s) do not receive these packets.
Select In-Band to have the Switch send the packets to all ports except the
management port (labelled MGMT) to which connected device(s) do not
receive these packets.
Management IP Address
Use these fields to set the settings for the out-of-band management port.
IP
Address
Enter the out-of-band management IP address of your Switch in dotted
decimal notation. For example, 192.168.0.1.
IP Subnet
Mask
Enter the IP subnet mask of your Switch in dotted decimal notation, for
example, 255.255.255.0.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal
notation, for example, 192.168.0.254
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
IP Interface
Use these fields to create or edit IP routing domains on the Switch.
IP
Address
Enter the IP address of your Switch in dotted decimal notation, for
example, 192.168.1.1. This is the IP address of the Switch in an IP routing
domain.
IP Subnet
Mask
Enter the IP subnet mask of an IP routing domain in dotted decimal
notation, for example, 255.255.255.0.
VID Enter the VLAN identification number to which an IP routing domain
belongs.
Add Click Add to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This field displays the index number of an entry.
IP Address This field displays IP address of the Switch in the IP domain.