1 transceiver installation, 2 transceiver removal – ZyXEL Communications XGS-4526 User Manual
Page 37
Chapter 3 Hardware Overview
XGS-4526 User’s Guide
37
To avoid possible eye injury, do not look into an operating fiber-
optic module’s connectors.
3.1.3.1 Transceiver Installation
Use the following steps to install a mini GBIC transceiver (SFP or XFP module).
1
Insert the transceiver into the slot with the exposed section of PCB board facing
down.
Figure 9 Transceiver Installation Example
2
Press the transceiver firmly until it clicks into place.
3
The Switch automatically detects the installed transceiver. Check the LEDs to
verify that it is functioning properly.
Figure 10 Installed Transceiver
3.1.3.2 Transceiver Removal
Use the following steps to remove a mini GBIC transceiver (SFP module).
1
Open the transceiver’s latch (latch styles vary).
Figure 11 Opening the Transceiver’s Latch Example