ZyXEL Communications XGS-4526 User Manual
Page 91
Chapter 8 Basic Setting
XGS-4526 User’s Guide
91
BPDU
Control
Configure the way to treat BPDUs received on this port. You must activate
bridging control protocol transparency in the Switch Setup screen first.
Select Peer to process any BPDU (Bridge Protocol Data Units) received on
this port.
Select Tunnel to forward BPDUs received on this port.
Select Discard to drop any BPDU received on this port.
Select Network to process a BPDU with no VLAN tag and forward a tagged
BPDU.
CX4 Cable
This field is available when you install an EM-412 module in the Switch’s
optional uplink module slot (see
). Select the
number of meters for the length of the 10GBASE-CX4 cable you use to
connect between the Switch and another switch for stacking.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 15 Basic Setting > Port Setup (continued)
LABEL
DESCRIPTION